When a program modification such as the following has been done, it is recommended to create a new project and acquire the target logs again then conduct a scan.
- Add a new parameter
- Change a parameter name
- Change response contents from the server greatly
On the other hand, it is a minor modification on the program other than the above, There is a way to conduct rescanning by using the existing project.
It is recommended to decide the project management method according to the operation policy.
(1) Re-scanning only the modified part (vulnerabilities) individually
When a modified part is small, such as the case that only a specific vulnerability is modified, It is possible to scan again only the individual signatures from the "resend" icon in the scan result list.
The correction has been successful when the vulnerability is not detected again by resending.
(2) Re-scanning the entire site
It is convenient to copy and use the target project from the project list before rescanning.
Copying a project, the scanning target logs and scanning settings are copied as they are, however the scan result is removed, which enables separately management from the previous scan result.
In this case, it is possible to output report about rescanning result alone.
<Copying a project>
1. Open the project list page.
2. Click the "Copy" icon (the left of "Process" column) of the project to copy.
3. Enter an arbitrary name and click the "Execute" button.
Once a scan is completed, it is recommend to export the project and saving it outside.
Exported projects can be imported and use again.